• Home
  • Blog
  • H1 UNLIMITED BOAT RACING | FOLSOM LAKE | SACRAMENTO |

H1 UNLIMITED BOAT RACING | FOLSOM LAKE | SACRAMENTO |

BOAT_AT_BOAT_SHOW

H1 UNLIMITED BOAT RACING | FOLSOM LAKE | SACRAMENTO |

H1 UNLIMITED BOAT RACING comes to Folsom Lake.

article sited from http://www.h1unlimited.com/hydros-101/

A modern Unlimited Hydroplane is the world’s fastest racing boat, capable of speeds in excess of 200mph. It represents the product of over 100 years of evolution in race boat design and incorporates the most powerful engines, most advanced construction techniques and the best safety systems available in boat racing today. All Unlimited Hydroplanes are a “three point” design, meaning they are designed to only touch the water at three points when racing: at the rear of the two front “sponsons” (the projections of the hull in front of the driver cockpit), and the propeller at the rear of the boat. “Runners” under the sponsons and “shoes” at the rear of the boat are generally all that touch the water during race conditions. A modern Unlimited is made of aluminum, fiberglass, carbon fiber and graphite composites, and weighs a minimum of 6750 pounds in race trim. The boats are between 28 and 32 feet long, 12 to 14 1/2 feet wide and about seven feet from the bottom of the rudder to the top of the rear wing.

Driver safety is paramount in the design and operation of an Unlimited, so the boats have a number of systems designed to keep the driver safe in the case of an accident. The fully enclosed cockpit is the primary safety feature, incorporating a full interior roll cage that is bonded to the cockpit shell to maintain the integrity of the driver area. The windows are cut from the canopy of F-16 fighter jets, giving the driver ultimate protection, yet allowing him to see clearly. Five point quick-release harnesses are used to keep the driver strapped into the seat and an escape hatch is built into the floor of the cockpit to allow the driver to escape if the hydroplane flips and lands upside down. Every driver is required to wear a certified helmet and a HANS device for head and neck protection.  He also wears a mask that incorporates an on-board air supply that allows him to breathe in case the cockpit fills with water, but also lets him communicate via the onboard radio. A “Rotor Burst protection System” (RBPS) is in place around the “hot end” of the engine to contain the fragments in case of a catastrophic failure of the turbine’s power rotor.

All of today’s unlimited hydroplanes are powered by a single Lycoming T-55 L-7 turbine engine that once powered our military’s Chinook helicopters from as far back as the Vietnam War. The turbine is capable of outputs of around 3000 HP and runs on Jet-A (kerosene) fuel. The large tail pipe in the back of the boat is only to allow heat to exit; no thrust is created from the exhaust. The engine’s output is hooked to a “gearbox” that has a single adjustable gear ratio that reduces the engine speed to the appropriate output shaft speed to make the propeller work most efficiently. A “long shaft” transfers the gearbox output through the bottom of the boat to the “strut” where the “short shaft” connects to it with a coupler. The short shaft has the propeller connected to the end and it allows the prop to be easily removed after every heat for inspection.

There is a fixed wing on the rear of the boat that can only be adjusted when in the pit area. This wing is only used for stabilizing and trimming the boat so that very little of the boat’s rear running surfaces touch the water. The second wing on the boat is located at the front of the “pickle fork” nose. Unlike the rear wing, this “canard” is actually controlled during racing by the driver via foot pedals. The canard allows the driver to more easily “fly” the boat, pushing the rear of the canard down to create lift and raise the nose of the boat, or raising it to lower the nose of the boat if it gets too high and is in danger of “blowing over”. The driver will also manipulate the canard in the turns or when rough water and windy conditions persist.

 

Salt buildup leads to pre-ignition: U-37 Degree Men at Air Guard Championship in San Diego 2010

The large “cowling” behind the driver cockpit functions as an aerodynamic device and as a “scoop” to funnel intake air to the engine. The rear of the cowling is vented to allow for excess air to pass through so as not to trap air that would otherwise slow the boat down. During saltwater races, an additional extension to the cowling may be used to prevent saltwater from being ingested into the engine. Excessive saltwater ingestion will almost instantly reduce engine output due to the buildup of salt residue on the turbine blades. This buildup effectively changes the compression ratio of the engine, allowing for “pre-ignition” (like a backfire on an automotive engine) that will shoot large flames out of the back of the engine (see image at right), and can even damage an engine.

A single three blade, 16″ diameter  propeller is allowed. Ideally, only one propeller blade should be touching the water when at racing speeds. Different pitch propellers are chosen for use based on course length, conditions and starting position. Race props can cost in excess of $15,000.The prop creates the distinctive “roostertail” behind the boat, raising literally tons of water into the air for up to 300 feet behind the boat.

The skidfin is a large metal fin that is attached to the area at the rear of the left sponson that allows the boat to “dig in” and make a turn without skipping across the water. The wall of water the skidfin throws up in the corner is one of the most spectacular sights in boat racing, reaching heights of nearly 50 feet and extending for 6-7 boat lengths behind the boat.

The rudder is a relatively small metal blade that is located in a bracket extending from the transom at the right rear of the boat that acts to steer the boat through the corners. The rudder only becomes truly effective at higher race speeds and makes maneuvering at low speeds somewhat challenging. A water pickup at the base of the rudder feeds onboard cooling and lubrication systems.

All Unlimiteds carry onboard digital recording devices that capture different streams of data, from engine speeds and fuel flow to wing angles and temperatures. All turbine engines are limited to 4.1 gallons per minute fuel flow and less than 115% “N2″ speed. N2 speed is a pre-determined upper RPM limit that the engine cannot exceed for more than five seconds. The data recorders log these two critical data streams and are reviewed by officials at the end of every qualifying attempt and heat.  Fuel flow and N2 violations will void a qualifying speed and will disqualify a boat from the Heat in which violation occurs.

RACE FORMAT:

Each U n l i m i t e d Hydroplane must qualify for the heat races at 130 mph or higher. The top qualifier receives 100 race points, runner-up receives 80 points, third highest qualifier 70 points, fourth 60, fifth 50, sixth 40, and the remaining boats get 30 points each. The qualified teams are admitted into the flights of Heats. Because there are too many boats to run at once they are split into groups represented by an alphabetical letter. Traditionally, there are Heats 1-A, 1-B, 1-C. Once the first Heats are finished and points have been assigned, another drawing is made and the boats run 2-A, 2-B, 2-C. Finally, the third set of Heats is run. All qualifying Heats are three laps and the winner-take-all final is five laps, but since the Madison Regatta is being run on a shorter course than normal this season, the Heats in Madison will be run for more laps to equal the race distance.

After each Heat, boats are awarded points based on how they finished: First place, 400 points; Second, 300 points; Third place, 225 points; Fourth place 169 points; Fifth place 127 points. The boats who have accumulated the most points make it to the winner-take-all final.

THE START:

Prior to the start of each preliminary heat and winner-take all final, there is an official clock that will count backwards starting at “10 to the 5″ – this means that there fifteen minutes to the start of the heat. Most boats will be lowered by crane into the water at this point. At “5 to the 5″, all drivers will be strapped into the boats with their safety gear in place. Most drivers will enter the race course when there are about five minutes remaining on the official clock. At the one minute mark or one minute “gun” all boats racing in the Heat or Final must be up and running.

Since the shortest way around the course is on the inside, Lane 1 is the preferred lane to start in. All boats will be allowed to “fight for lanes” prior to the start, prioritizing pre-race strategy and boat setup. Once lanes are established at the entrance to the second turn prior to the start, boats will then position themselves so that they reach the start/finish line as the official clock strikes zero signifying the start of the race. Drivers do not want to “beat the clock” or they will be assessed a penalty, usually in the form of an addition lap or additional time added to their finishing time.

THE RACE:

Speed is the key to winning, but speed alone may not get a boat to the checkered flag first. Strategy is the key to positioning the boat in the right lane to match the way the boat has been set up, and driving defensively can keep a faster boat behind a slower boat. At all times during a race, there are numerous things a driver must do: communicate via radio to their Crew Chief or “radio man”, manage their boat speed before the start and “fight” for the lane they feel will give them the best chance of success without jumping the gun, watch all the other boats to insure they maintain proper distance, watch out for the buoys on the inside of the course, and once the race is under way, “fly” their boats at the maximum speed they’re capable of without flipping!

Roostertails and skidfin water are the most spectacular parts of hydroplane racing but present the most danger to other drivers on the course. Both lift TONS of water high in the air and both will lift other hydroplanes out of the water as well. All boats are required to have “overlap” before a lane change can be made. This overlap is 7 boat lengths – one roostertail length – and it allows the roostertail to subside so as not to endanger the following driver. Jeff Bernard’s 2009 flip in Doha (video) shows the power of the roostertail.

 

Dave Villwock rides up J. Michael Kelly’s skidfin water in Doha, 2010. Image by Jim Simpson.

If a driver on the inside somehow drifts into a boat on the outside or is “pinched” by the boat on the outside, it is almost guaranteed the inside boat will be lifted out of the water and flipped by the wall of water coming off the skidfin. Dave Villwock’s near flip in Heat 1B in Doha at the 2010 UIM World Championship (video) shows the amazing power of the skidfin water.

Since the “lanes” that comprise a race course are about thirty feet wide, a boat running in lane six will travel much farther than a boat in lane one. However, the boat in lane one must make a much tighter arc to make it around the corner and scrubs off lots of speed to do it. The boat in an outside lane can make a much gentler turn allowing him to carry much more speed through to the exit of the corner. This means that the optimum combination of gear ratio and propeller pitch varies dramatically depending on which lane the boat races in. The correct choice of ratios and prop means a boat can win from the outside if the inside boat can’t put enough power down to get out of the corners fast enough. Conversely, the leading boat is allowed to establish which portion of their 30 foot lane they choose to race in. By staying in the outside of their lane, a slower boat on the inside can force a faster boat on the outside to make a much wider arc. This will force the outside boat to run a longer course potentially slowing them down and allowing the slower boat on the inside to win.

Depending on the choices made during setup, almost every conceivable combination of faster and slower boats in different lanes can produce dramatic racing and very unexpected results. Every team on the water is capable of bringing home a race win – that’s what makes Unlimited Hydroplane racing one of the most amazing and spectacular forms of racing in the world!

H1 UNLIMITED BOAT RACING